The following steps provide the process of setting up the schema, building the IP, and configuring the OpenAccessSDK810_C service.
1. Build the IP module:
Open the Visual Studio project under install_dir\ip\oac\example and build the IP module. The projects are configured to place the DLL in the install_dir\ip\bin folder.
For example1, example2, and example3, the module name is oadamip_example.dll.
For the memory example, the module name is oadamipmem.dll.
2. Run the OpenAccess SDK Management Console and modify the OpenAccessSDK810_C service to specify the IP module and schema\example as the schema path.
a. Run the OpenAccess SDK Management Console.
b. Expand the OpenAccessSDK810_C service to the IP Parameters folder.
c. Modify ServiceIPModule to oadamip_example.dll (oadamip_example1.dll, for example1). For the memory sample, set this attribute to oadamipmem.dll.
d. Expand the Data Source Settings node:
Select example for the example1, example2, or example3 example.
Select memory for the memory example.
e. Select the IP Parameters folder.
f. Modify DataSourceIPSchemaPath to install_dir\ip\schema\example, where example is replaced by example1, example2, example3, or memory.
g. Save the settings and restart the OpenAccessSDK810_C service.
3. From an OpenAccess SDK client, connect to the IP module you have just built:
Use the example data source for example1, example2, or example3. These IP examples do not require a user name and password.
Use the memory data source to connect to the memory sample. memory requires the user name pooh and the password bear.
For example1, example2, and example3, the module name is oadamip_example.dll.